TABLE OF CONTENT
Title page
Certification
Dedication
Acknowledgement
Table of content
CHAPTER ONE
1.0 Introduction
1.1 Objective of the project design
1.2 Preamble
1.3 Justification of the project
1.4 Scope of the project
1.5 Constraints
1.6 Block diagram overview
1.7 Project report organization
CHAPTER TWO
Literature review
2.1 Origin/History of the project
2.2 Technology of DOT MATRIX display
2.3 Uses of the project
2.4 Advantages of the design
2.5 Types of DOT MATRIX display
CHAPTER THREE
3.0 Design process and implementation
3.1 The mains unit
3.2 The power supply unit
3.3 The address generator’s unit
3.4 The memory unit/micro-controller
3.5 The drivers unit
3.6 Design process
3.7 Preliminaries of the design
3.8 Detail of design
3.9 Software design
3.10 Development process
3.11 Program entry and editing
3.12 Assembling and linking
3.13 System control program steps
3.14 Software for the programmer
3.15 Soft to hard design
3.16 Flash or eprom programmer
3.17 Using a personal computer to program the AT89C51
CHAPTER FOUR
Methodology
4.1 Information gathering
4.2 data analysis
4.3 System design approaches
4.4 Choice of design approaches
4.5 Data flow arrangement
4.6 System flowchart
CHAPTER FIVE
Summary and conclusion
5.1 Summary of achievement
5.2 Problems encountered and solution
5.3 Suggestions for further improvement
5.4 Conclusion
References
Appendix 2: Acronyms and their meanings
CHAPTER ONE
INTRODUCTION
The purpose of this project is to produce a narrative description of the design and construction of a microcontroller based dot matrix advert display. Firstly computer aided design is the modeling of physical system on Computers allowing both interactive and automatic analysis of design variant and the expression of design in a form suitable for manufacturing. This follows by explaining the microcontroller based dot matrix advert display as a device which is fast gaining wide acceptance and application in the present days due to its ability to provide a very high precision timing. The dot matrix advert display can be describe as an electro-mechanical system for processing information in which the information is represented by physical quantities, which are so constrained to take only discrete values that can be referred to as binary signals.
In this design we have implored the use of both hardware and software to bring about the entire project. The hardware....================================================================
Item Type: Project Material | Size: 68 pages | Chapters: 1-5
Format: MS Word | Delivery: Within 30Mins.
================================================================
